For this driver version, in order to enable WoL, the e driver must be loaded prior to shutting down or suspending the system. If during this process you are asked for the driver or module name, the name for the Linux Base Driver for the Gigabit Family of Adapters is igbvf. You can use the insmod command for 2. As this value decreases one may want to consider increasing the TxDescriptors value to maintain the same amount of frame memory. Or do I have to add them to some boot. BB code is On. There are three classes defined:

Uploader: Mukinos
Date Added: 8 March 2013
File Size: 58.78 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 16930
Price: Free* [*Free Regsitration Required]

Mostly Debian’s apt tools is great, until it goes wrong. This parameter is a bit mask that specifies which speed and duplex settings the board advertises.

Using kernel versions earlier than 3. Also the fact that Slackware doesn’t keep changing updating I find much easier to deal with.

However, development has already began for the upcoming Intrepid Ibex 8. The Linux base drivers support the 2. This parameter is supported only onand later adapters.

I have a similar ethernet card in my Dell, and the drivers existed in You can find more details using command man modprobe.

In this mode, which operates the same as mode 3, the InterruptThrottleRate will be increased stepwise to for traffic in class “Lowest latency”.


CONFIG_E1000E: Intel(R) PRO/1000 PCI-Express Gigabit Ethernet support

Refer to the Speed and Duplex section of this readme for more information on the AutoNeg parameter. If the bytes per second rate is approximately equal, the interrupt rate 80003ds2lan drop as low as interrupts per second.

If you’d like to contribute content, let us know. This setting is not saved across reboots.

Linux Kernel Driver DataBase: CONFIG_EE: Intel(R) PRO/ PCI-Express Gigabit Ethernet support

The default operation is auto-negotiate. The hardware can handle many more small packets per second however, and for this reason an adaptive interrupt moderation algorithm was implemented. If you encounter the problem in an adapter, and the chipset is an oinux one, you can verify that your adapter needs the fix by using ethtool:.

I’m running Slackware 80003e2slan trying to compile the driver by running make install, the following error may occur: EEE 1 enabled A link between two EEE-compliant devices will result in periodic bursts of data followed by periods where the link is in an idle state.

These correspond to the following product names: The two other lines, I don’t understand either what they are doing.

All driver 80003ds2lan, in-memory queues, and receive buffers will be allocated on the node specified. It’s there because the other devices don’t work.


This driver supports receive multiqueue on all kernels that support MSI-X. Sign up or log in Sign up using Google. Several adapters with the chipset display “TX unit hang” messages during normal operation with the ee driver.

The board advertises all supported speed and duplex combinations, and it links at the highest common speed and duplex mode IF the link partner is set to auto-negotiate.

Launchpad Janitor lnux wrote on This may differ for various Linux distributions.

This value, in units of 1. DSL is great at what it does, just difficult to know where to change something.

Intel(R) PRO/ (EB) ee driver help, Slackware

The e driver is no longer maintained as a standalone component. If the iintel is reporting dropped transmits, this value may be set too high causing the driver to run out of available transmit descriptors.

As this value decreases one may want to consider increasing the TxDescriptors value to maintain the same amount of frame memory. Doing so can impact Tx performance.